Kinefinity Movcam NATO Slider on Top Plate

This slider bolts straight to a MAVO body or to the top plate in the KineKIT bundles and gives the rig a NATO rail, so any NATO-mount top handle slides on and comes off without tools. Two mounting screws hold it down, and a recessed locking pin stops a handle sliding clean off the end when it is loosened.

It also carries a 15mm rod receiver, which is the part that turns it from a handle mount into a build point: an EVF arm, a monitor mount or a top-mounted accessory can run off rods above the camera rather than fighting for the same 1/4 inch holes.