PTZOptics 3G-SDI Plenum Cable, BNC Male to Male

This is the cable that carries a PTZOptics camera's SDI output to wherever the picture is going: a switcher, a frame grabber, a recorder, a monitor at the back of the room. It is built on Belden 1695A, which is the coax most integrators specify for 3G-SDI runs because it holds the signal at length rather than only on paper, and it is terminated BNC male to BNC male at both ends.

The jacket is plenum rated, which is the part that matters when the run goes above a ceiling tile in a commercial building and an inspector is going to look at it. The cable is white, so it disappears against a ceiling instead of drawing a line across it. Four lengths cover the usual camera positions, from a short hop at the podium to a 100 foot run to the control room.