Adaptive Technologies BC3-8 Beam Clamp (3" - 8" Flange)

The BC3-8 clamps directly onto structural I-beam flanges between 3" and 8" wide (76-203mm) to create a load-rated overhead rigging point without welding or drilling into the beam. Installation only needs a hand wrench, and the beam flange has to stay parallel to the floor to hold the stated working load.

All-steel construction with a black powder coat finish. The BC3-8-0 gives a single open hang point, the BC3-8-2 doubles that to two offset hang points on the same clamp, and both hold to a 5:1 design factor. Recommended install torque is 40-50 ft/lb.