Eartec EVADE INT Interface Module

This is the EVADE-side counterpart to the HUB interface: the module that ties an Eartec CMod conference module into an intercom that is already installed and already wired. The circuit plugs into the party line, the CMod plugs into the module, and roaming EVADE wireless headsets join the same conversation as the wired positions. Level dials on the module set the balance between the two halves.

Each version is built for one wired system, so order by the intercom on your wall rather than by the connector. Clear-Com, Telex and AudioCom, RTS, and Production Intercom modules connect on 3-pin XLR female; the Blackmagic module is a 4-wire RJ45 connection. The CMod base and EVADE headsets are purchased separately.

Function	Wired party-line to EVADE wireless interface module
Connection, 2-Wire Systems	3-pin XLR female
Connection, Blackmagic	4-wire RJ45
Level Control	Dial adjustment on module, wired-to-wireless balance
Wireless System	EVADE full duplex, up to 9 users
Radio	DECT, no FCC licensing required
Requires	Eartec CMod base, purchased separately