Rode Wireless Micro Camera Kit
The Wireless Micro Camera Kit takes the phone-sized Wireless Micro system and gives it a camera receiver, so the same two clip-on transmitters feed a mirrorless body on a shoot and a phone on the next one. Each transmitter weighs 12 g with its own omnidirectional capsule built in, clips or magnets to a collar, and captures 24-bit/48kHz audio with 135dB SPL headroom and a 73dB signal-to-noise ratio over a link that holds past 100 m.
The charging case holds 490 mAh, refills the transmitters through pogo-pin contacts in about 2 hours and carries two extra charges, which is roughly 14 hours on top of the 7 hours each transmitter runs unaided. It works with iOS 14 and later over Lightning or USB-C and Android 11 and later over USB-C, and the whole kit including case comes in at a little over 100 g.
| Polar Pattern | Omnidirectional |
|---|---|
| Frequency Range | 20 Hz - 20 kHz |
| Maximum SPL | 135 dB SPL |
| Signal-to-Noise Ratio | 73 dB |
| Audio Format | 24-bit / 48 kHz |
| Transmission Range | Over 100 m |
| Operating Time | 7 hours per transmitter, plus 2 case charges (about 14 hours) |
| Compatibility | iOS 14 and above (Lightning and USB-C), Android 11 and above (USB-C) |












