Ashly FX500.2 2-Channel DSP Install Amplifier

The FX500.2 is a two-channel 500 W amplifier with the FX series DSP built in. Like the other 500 and 750 models it will drive 2-ohm loads as well as 4 and 8, so a stubborn parallel run does not force a bigger amplifier.

The DSP is a full system processor rather than a trim control: sensitivity, routing, gain, parametric EQ, compressor, limiter, FIR filters, crossover, polarity and delay on every input and output, with speaker presets that can be saved and recalled per channel. Configuration is done in a browser over Ethernet or the built-in WiFi hotspot with nothing to install. Inputs are balanced mic/line on removable Euroblock plus unbalanced RCA and two channels of SPDIF, and outputs run Low-Z at 4 or 8 ohms or bridge into 70/100 V. Warranty is five years.