Shure KSM141/SL Stereo Pair
The KSM141/SL Stereo is a matched pair of end-addressed studio condensers with a rotating collar that switches each mic between a true cardioid and a true omnidirectional pattern - a genuine dual-pattern capsule, not a diaphragm trick. That makes the pair equally at home as a spaced or coincident stereo array on drum overheads, acoustic guitar, piano, or room, and rugged enough to follow the session onto a live stage.
A 2.5-micron, 24-karat gold-layered Mylar diaphragm and a Class A transformerless preamp give fast transient response and low distortion, and a three-position pad (0, 15, 25 dB) lets the pair sit in front of very loud sources. Each mic runs on 48V phantom power. The champagne-finish pair ships in an A141SPC case with two A100WS windscreens, two A57F mic clips, and an A27M stereo bar.
- Output Impedance150 Ω
- ConnectorThree-pin professional audio (XLR), male, balanced
- Polar PatternCardioid, Omnidirectional (selectable)
- Frequency Response20 to 20,000 Hz
- Sensitivity (open circuit voltage, @ 1 kHz, typical)-37 dBV/Pa (14.1 mV)
| Cartridge Type | Electret |
|---|---|
| Polar Pattern | , Omnidirectional (selectable) |
| Frequency Response | 20 to 20,000 Hz |
| Output Impedance | 150 Ω |
| Sensitivity (open circuit voltage, @ 1 kHz, typical) | -37 dBV/Pa (14.1 mV) |
| Maximum SPL (1 kHz at 1% THD) | PAD ON: 170 dB (5000 Ω load), 164 dB (2500 Ω load), 159 dB (1000 Ω load); PAD OFF: 145 dB (5000 Ω load), 139 dB (2500 Ω load), 134 dB (1000 Ω load) |
| Signal-to-Noise Ratio | 80 dB |
| Dynamic Range (@ 1 kHz) | 5000 Ω load: 131 dB; 2500 Ω load: 125 dB; 1000 Ω load: 120 dB |
| Clipping Level (20 Hz to 20 kHz, 1% THD) | 5000 Ω load: 15 dBV; 2500 Ω load: 9 dBV; 1000 Ω load: 3 dBV |
| Self Noise (equivalent SPL, A-weighted, typical) | 14 dB SPL-A |
| Common Mode Rejection (10 Hz to 100 kHz) | ≥50 dB |
| Attenuator Switch | 0, -15, -25 dB |
| Low-Frequency Filter Switch | Flat, -6 dB/octave below 115 Hz, or -18 dB/octave below 80 Hz |
| Connector | Three-pin professional audio (), male, balanced |
| Polarity | Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3 |
| Power Requirements | 11 to 52 V DC (IEC-61938), 4.7 mA, maximum |
| Net Weight | 156 g (5.5 oz.) |
| Source | Full specifications on shure.com |

- Case (A141SPC)
- 2 x Windscreen (A100WS)
- 2 x Microphone Clip (A57F)
- Stereo Microphone Adapter (A27M)










