Crestron CM2-KPEX Cameo 2 In-Wall Wireless Keypad
The CM2-KPEX is the control-only member of the Cameo 2 in-wall line. It has no load terminal: it sits on the infiNET EX mesh and sends button presses to the control system, which then moves lights, shades, audio or anything else in the program. That makes it the part to use at a second entry, beside a bed, or anywhere a room needs another point of control without another dimmer in the circuit.
It takes line power at 100-240VAC or 60VDC at 30 mA from a SolaHD SDP 1-48-100T supply, sold separately. Buttons respond to normal, tap, double-tap and press-and-hold, so a single cap can carry more than one scene. The full keypad shows six RGB backlit text regions with six matching indicator regions over up to six programmable buttons, and the bottom four can be paired into side-to-side rockers; the RKR version uses one large rocker with three RGB text regions and a full RGB bargraph. ENGRAVED variants take custom engraving on small, medium or large caps. Neutral is required. A Cameo 2 faceplate and a Crestron wireless gateway are sold separately.
| Communications | infiNET EX 2-way RF, 2.4 GHz ISM channels 11-26, IEEE 802.15.4 |
|---|---|
| Wireless Range | 150 ft (46 m) indoor, 250 ft (76 m) outdoor to nearest mesh device |
| Line Power | 100-240 VAC, 50/60 Hz |
| DC Power | 60VDC, 30 mA (SolaHD SDP 1-48-100T supply, sold separately) |
| Controls | Full keypad models: 2 to 6 programmable buttons; RKR models: one large rocker |
| Button Events | Normal, Tap, Double-Tap, Press and Hold |
| Connections | (4) 14-12 AWG screw terminals: HOT, REM, NEU, GND (neutral required) |
| Dimensions | 4.06 in. H x 1.75 in. W x 1.59 in. D (103 x 45 x 40 mm) |










