Shop all Crestron
Crestron AMP-X500 X-Series Amplifier, 500 W
The AMP-X500 shares one power budget across its channels instead of dividing it evenly. Each channel is rated at 250 W into 4 or 8 ohms, 500 W into 8 ohms only, or 500 W at 70V or 100V, with total simultaneous output across all channels capped at 500 W. In practice that means a designer can put the power where the room needs it, a pair of large mains and several small fills, without over-buying an amplifier per zone.
Balanced and unbalanced inputs are accepted on the same connector. Protection covers overcurrent, undervoltage, over temperature, DC offset, and extreme high frequency, and a power-saver mode sleeps the amplifier after 25 minutes with no signal, waking in about half a second on a 0.44 mV threshold.
| Input Signal Types | Balanced or unbalanced analog line-level |
|---|---|
| Output Power Per Channel | 250 W (4 or 8 ohms), 500 W (8 ohms only), 500 W (70V/100V) |
| Total Output Power | Will not exceed 500 W simultaneously across all channels |
| Frequency Response | 20 Hz to 20 kHz, 0.5 dB at 1 W |
| THD+N | 0.1% at 1 kHz at -3 dB full rated output power |
| S/N Ratio | 103 dBA, 20 Hz to 20 kHz, balanced |
| Input Sensitivity | 1.23 Vrms, +4 dBu balanced; 0.316 Vrms, -10 dBV unbalanced |
| Protection | Overcurrent, undervoltage, over temperature, DC offset, extreme high frequency |
