Rode NTH-Mic Headset Microphone for NTH-100
The NTH-Mic converts an NTH-100 headphone into a broadcast headset. It plugs into the 3.5mm bayonet jack on the earcup and locks, so it will not pull loose mid-session, and it can be fitted to either side depending on how the desk is laid out.
The capsule is a permanently polarized omnidirectional condenser with a JFET impedance converter, running on plug-in power. Self-noise is 27dBA typical with a 67dB signal-to-noise ratio, a 92dB dynamic range and 106dB SPL maximum at 1% THD. The whole microphone weighs 5 grams and is 123mm long.
- Maximum Output Level307mV (@ 1kHz, 10% THD into 1K ohms load)
- Frequency Range20Hz - 20kHz
- Sensitivity38dB re 1 Volt/Pascal (12.59 mV @ 94 dB SPL) +/- 3 dB @ 1kHz
- Equivalent Noise Level (A-Weighted)27dBA Typical
- Acoustic PrinciplePermanently polarized
| Acoustic Principle | Permanently polarized |
|---|---|
| Active Electronics | JFET impedance converter |
| Frequency Range | 20Hz - 20kHz |
| Signal-to-noise Ratio | 67dB |
| Equivalent Noise Level (A-Weighted) | 27dBA Typical |
| Maximum SPL | 106dB SPL RMS (Plug-In Power, 1% THD) 123dB SPL RMS (Plug-In Power, 10% THD) |
| Maximum Output Level | 307mV (@ 1kHz, 10% THD into 1K ohms load) |
| Sensitivity | 38dB re 1 Volt/Pascal (12.59 mV @ 94 dB SPL) +/- 3 dB @ 1kHz |












