Pliant Technologies Tempest Headset PHS-SB100-U
The PHS-SB100-U is the single-ear SmartBoom PRO from Pliant shipped without a connector on the end of its cable. The headset is the same one the terminated models use: a cardioid dynamic microphone voiced for speech that turns its back on off-axis noise, a flexible ambidextrous boom that swivels to either side, and soft foam padding under an adjustable headband for operators who wear it through a whole show. The boom doubles as the mute - lift it and the mic is off, lower it and you are live - so muting never means fumbling for a switch. One ear stays open to the room, which is the point of the single-ear design.
The unterminated cable is for the systems that do not use a standard XLR headset jack. Solder on the connector the beltpack, panel, or wireless pack actually takes, and the same 5 ft removable lead swaps out in the field if it gets damaged. Because the cable detaches at the earcup, one headset can be re-terminated for a different fleet later instead of being retired.
| Microphone Type | Dynamic |
|---|---|
| Polar Pattern | Cardioid (uni-directional) |
| Mic Frequency Response | 50-10,000 Hz |
| Mic Sensitivity | -58 dBV/Pa |
| Mic Output Impedance | 200 ohms |
| Speaker Frequency Response | 20-20,000 Hz |
| Speaker Impedance | 100 ohms nominal |
| Form Factor | Single-ear |
| Mic Boom Length | 8.50 in. (215.90 mm) |
| Cable | Removable, 5.00 ft. (1.52 m) |
| Connector | Unterminated |
| Weight | 8.1 oz. (229.63 g) without cable |













