sE Electronics FluxCore FCP1 Hi-Z Passive DI Box
The FCP1 is the passive model in sE's FluxCore DI series. Its 650 kohm input puts little load on a bass, guitar or keyboard, and it needs no phantom power or batteries. A switch sums the two 1/4 in. inputs to mono, and a separate 3.5 mm TRS jack takes a laptop, media player or backing-track rig, so a stereo source lands on one balanced XLR and one console channel.
The signal runs through a shielded transformer for galvanic isolation, with sE's on+ ground lift for hum and RF. A 15 or 30 dB pad handles a guitar or bass amp output, and the POLAR switch inverts polarity when the DI sits alongside a miked cab. The steel case is 100 mm wide and stacks; a non-slip mat, hook-and-loop pads for a pedalboard and screws for mounting four units on a 1U rack shelf are in the box.
- Dimensions (W x H x D)100 x 39 x 127 mm (3.94 x 1.54 x 5.0 in.)
- Input Impedance650 kohms (pad at 0 dB); 12 kohms at -15 dB
- Max Input Level (0.5% THD)30 dBV (33 V) / 45 dBV (185 V) / 60 dBV
- Output Impedance168 ohms (recommended load >1k ohms)
- ConnectorsIn / L: 1/4 in. TS jack; Thru / R: 1/4 in. TS jack
| Type | Passive DI, transformer-isolated, HiZ input |
|---|---|
| Frequency Range | 18 - 30,000 Hz (-0.3 dB) |
| Input Impedance | 650 kohms (pad at 0 dB); 12 kohms at -15 dB; 10 kohms at -30 dB |
| Gain | -20 dB |
| Attenuation Pad | 0 / -15 / -30 dB |
| Max Input Level (0.5% THD) | 30 dBV (33 V) / 45 dBV (185 V) / 60 dBV (1,044 V) at 0 / -15 / -30 dB pad |
| Output Impedance | 168 ohms (recommended load >1k ohms) |
| Powering | None required (passive) |
| Connectors | In / L: 1/4 in. TS jack; Thru / R: 1/4 in. TS jack; In: 3.5 mm (1/8 in.) TRS stereo jack; Out: 3-pin male |
| Dimensions (W x H x D) | 100 x 39 x 127 mm (3.94 x 1.54 x 5.0 in.) |
| Weight | 795 g (28.0 oz.) |
| Included | Non-slip mat, hook-and-loop pads, 4 rack-mount screws, sE logo stickers, user manual |









