sE Electronics FluxCore FCA1 Ultra Hi-Z Active DI Box
The FCA1 is the active model in sE's FluxCore DI series, built for instruments that need a very high input impedance. Its Ultra-HiZ input switches between 10 Mohms, 100 kohms and 10 kohms, so a piezo pickup or a passive guitar or bass pickup sees almost no load and keeps its top end and dynamics. The DYNAMITE boost adds 15 or 30 dB of gain at the box, before a long snake run or a noisy stage gets a chance at the signal.
A shielded transformer gives galvanic isolation, and sE's on+ ground lift deals with hum and RF. A 15 or 30 dB pad takes an amp's speaker or line output, and the POLAR switch flips polarity when you blend the DI with a miked cab. It runs on 48 V phantom, with +48 V LEDs on the front and rear. The steel case is 100 mm wide and stacks; a non-slip mat, hook-and-loop pads for a pedalboard and screws for mounting four units on a 1U rack shelf are in the box.
- Dimensions (W x H x D)100 x 39 x 127 mm (3.94 x 1.54 x 5.0 in.)
- Input Impedance10 Mohms / 100 kohms / 10 kohms, switchable (pad at 0 dB)
- Output Impedance60 ohms (recommended load >1k ohms)
- ConnectorsIn: 1/4 in. TS jack; Thru: 1/4 in. TS jack
- Frequency Range10 - 80,000 Hz (-0.3 dB)
| Type | Active DI, transformer-isolated, Ultra-HiZ input |
|---|---|
| Frequency Range | 10 - 80,000 Hz (-0.3 dB) |
| Input Impedance | 10 Mohms / 100 kohms / 10 kohms, switchable (pad at 0 dB) |
| Gain | 0 / +15 / +30 dB (DYNAMITE boost) |
| Attenuation Pad | 0 / -15 / -30 dB |
| Max Input Level (0.5% THD) | 8 dBV (2.75 V) / 24 dBV (15 V) / 39 dBV (87 V) at 0 / -15 / -30 dB pad |
| Output Impedance | 60 ohms (recommended load >1k ohms) |
| Powering | 48 V (IEC 61938), 7.2 mA |
| Connectors | In: 1/4 in. TS jack; Thru: 1/4 in. TS jack; Out: 3-pin male |
| Dimensions (W x H x D) | 100 x 39 x 127 mm (3.94 x 1.54 x 5.0 in.) |
| Weight | 795 g (28.0 oz.) |
| Included | Non-slip mat, hook-and-loop pads, 4 rack-mount screws, sE logo stickers, user manual |









