Martin Audio CDD10-WR 10" Weather-Resistant Coaxial On-Wall Loudspeaker
The CDD10-WR takes the 10-inch CDD outdoors. A 10" long-excursion LF driver shares a ferrite motor with a coaxial 1" exit polyimide compression driver in a 28 litre composite enclosure, producing 126dB peak from a box you can hang off a wall bracket. Differential Dispersion narrows the horizontal pattern from 110 to 75 degrees over distance, so a beer garden or a pool deck gets even coverage rather than one loud zone near the speaker.
Weatherproofing runs through the whole build: a zinc-plated, powder-coated mild steel grille with weatherised backing, stainless steel fixings, a low-profile push-lock connector under a sealed panel cover, and IP54 environmental rating for sheltered outdoor service. The coaxial drive unit is user-rotatable so the cabinet works portrait or landscape, and integral inserts take eyebolts, weatherised wall brackets or a horizontal yoke. Use it with an iKON amplifier or a DX4.0 controller for the correct presets and limiter protection.
| Type | Compact Coaxial Differential Dispersion passive two-way |
|---|---|
| Frequency Response | 65Hz - 20kHz +/- 3dB, -10dB at 55Hz |
| Drivers | LF 10" (250mm) long excursion, HF 1" exit polyimide dome compression |
| Rated Power | 250W AES, 1000W peak |
| Sensitivity | 96dB |
| Maximum SPL | 120dB continuous, 126dB peak |
| Nominal Impedance | 8 ohms |
| Dispersion | 110 - 75 deg horizontal, 60 deg vertical, user-rotatable |
| Environmental | Rated IP54, weatherised grille and sealed input panel |
| Dimensions / Weight | 323 x 513 x 310 mm (12.7 x 20.2 x 12.2 in), 15.5kg (34.2lbs) |













