Draper Targa 100" (60 x 80) 4:3 Electric Projection Screen, 220V

The Draper Targa is an electrically operated, surface-mounted projection screen with a 100-inch diagonal (60 x 80 inch) 4:3 viewing surface. The screen rolls straight up and down from a motor-in-roller - there is no tab-tensioning - with the fabric kept flat by a weighted dowel along the bottom edge. The roller and motor sit in a one-piece 22-gauge steel case with a flat back and endcaps that double as universal wall or ceiling hanging brackets; the case is about 5-7/8 inches high by 5-1/4 inches deep and comes in a scratch-resistant white finish, with black available.

This unit ships with a 220V motor for installations on international or export electrical service, with a three-position wall switch that stops or reverses the screen at any point. The surface is Draper's Matt White XT1000E (1.0 gain), a neutral all-purpose white. A quiet motor and Draper's LVC-IV low-voltage controller are available; part numbers run from 116133 through 116133QU.