Yealink AP08 Dante Digital Signal Processor
The AP08 handles 16 Dante inputs and 16 outputs, 8 of them with dynamic acoustic echo cancellation, alongside 4 x 4 analog channels and two USB 3.0 Type-B device ports. It applies noise cancellation and reverberation suppression, and Yealink Room Designer software sets audio routing and tunes the room automatically.
Three RJ-45 Dante LAN ports each act as IEEE 802.3at PSE with a 90 W total budget, so the AP08 can power up to three Yealink audio devices such as CS10 ceiling speakers or CM-series ceiling microphones. Control is over an RJ-45 management port, RS-232 and 8 GPIO in/out.
- SizeL360 x W189 x H44 mm
- Dante channels16 Dante input (8 AEC channels), 16 Dante output; 48 kHz
- LAN ports3 x RJ-45 Dante, each IEEE802.3at PSE
- Control portsMGMT RJ-45 for API control; RS232 3-pin Phoenix
- Dante frequency response50 Hz - 20 kHz
| Part number | 1303097 |
|---|---|
| Model | AP08 |
| Dante channels | 16 Dante input (8 AEC channels), 16 Dante output; 48 kHz, 24-bit |
| Dante frequency response | 50 Hz - 20 kHz |
| Analog inputs | 2 x RCA, 2 x 3-pin Phoenix (balanced, 48V ) |
| Analog outputs | 2 x RCA, 2 x 3-pin Phoenix (balanced) |
| USB | 2 x USB 3.0 Type-B device interfaces |
| LAN ports | 3 x RJ-45 Dante, each IEEE802.3at PSE; total maximum PSE 90 W |
| Control ports | MGMT RJ-45 for API control; RS232 3-pin Phoenix; GPIO in/out 1-8 |
| Power | 100-240 V, 50/60 Hz, 2A |
| Size | L360 x W189 x H44 mm |
| Weight | 2.2 kg |
| Operating temperature | 0 - 40 C |

- AP08 Dante Digital Signal Processor
- USB 3.0 cable
- Power cable
- Rack mount
- Phoenix connector









