Vaddio RoboSHOT IW Smart Glass OneLINK Bridge System (Primed)
The RoboSHOT IW recesses a full 10x PTZ camera into the wall behind a glass front frame, keeping a room clean while the camera stays protected and discreet. It is built on a 1/2.8-type Exmor CMOS sensor with 10x optical zoom (12x in super-wide mode) and a 73-degree wide field of view, shooting up to 1080p/60. This model uses smart glass that frosts to opaque when the camera is off and turns clear when it powers on, and ships with a primed front frame that can be painted to match the wall.
A single Cat-5e run over HDBaseT carries power, control and video to the paired OneLINK Bridge, which adds Vaddio's AV Bridge functionality: simultaneous uncompressed USB 3.0, HDMI and HD-SDI outputs plus two balanced audio inputs and outputs, turning the room into a BYOD conferencing space for soft clients. In the box: the RoboSHOT IW camera and back-box, a primed smart-glass front frame, left and right interior side plates, drywall hardware, the Vaddio IR Remote Commander, the OneLINK Bridge interface, a 48V power supply, an EZCamera RS-232 control adapter, four 3-position phoenix connectors, a 6 ft USB 3.0 cable, and an installation guide.
| Image Sensor | 1/2.8-type Exmor CMOS, 2.14 megapixel effective |
|---|---|
| Zoom | 10x optical (12x in super-wide mode) |
| Horizontal FOV | 73 degrees (wide) to 6.6 degrees (tele) |
| Resolutions | Camera up to 1080p/60; USB up to 1080p/60 |
| Pan / Tilt | Pan +/-31 degrees, Tilt +18 / -30 degrees |
| Bridge Outputs | Simultaneous USB 3.0, HDMI and HD-SDI, plus balanced audio |
| Power | Under 25W (PoE+) via OneLINK |
| Included | Camera and back-box, primed smart-glass frame, side plates, hardware, IR remote, OneLINK Bridge, 48V PSU, USB 3.0 cable, RS-232 adapter |









