Draper Targa 180" (105 x 140) 4:3 Contrast Grey XH800E Electric Projection Screen

The Draper Targa is an electrically operated, surface-mounted projection screen with a 180-inch diagonal (105 x 140 inch) 4:3 viewing surface. The screen rolls straight up and down from a motor-in-roller - there is no tab-tensioning - with the fabric kept flat by a weighted dowel along the bottom edge. The roller and motor sit in a one-piece 22-gauge steel case with a flat back and endcaps that double as universal wall or ceiling hanging brackets; the case is about 5-7/8 inches high by 5-1/4 inches deep and comes in a scratch-resistant white finish, with black available.

The standard motor mounts inside the roller on rubber isolation insulators and runs on 110-120V, with a three-position wall switch that stops or reverses the screen at any point. The surface is Draper's Contrast Grey XH800E (0.8 gain), a grey surface that lifts perceived contrast in rooms with some ambient light. A quiet motor and Draper's LVC-IV low-voltage controller are available; part numbers run from 116512 through 116512QU.