Shop all Whirlwind
Whirlwind XCHECKER Balanced Line Cable Checker
The Xchecker is a portable checker for common balanced audio lines. The tester carries a female XLR and the terminator carries a male XLR, so both connect directly to XLR wiring without adapters.
Because it is a two-piece design, one half goes at each end of an installed run, which lets you check permanent cabling up to 500 ft long from either end. It tests for inter-wire shorts, open conductors, non-standard wiring and intermittent conditions. An XLR cable is not included.
| Type | Balanced line cable checker |
|---|---|
| Design | Two piece, tester and terminator |
| Connectors | Female XLR on the tester, male XLR on the terminator |
| Faults detected | Inter-wire shorts, open conductors, non-standard wiring, intermittents |
| Maximum run tested | 500 ft of installed cabling |
| Not included | XLR cable |












