JMAZ Lighting Electro Y-DMX Through Splitter

The Y-DMX Through Splitter takes a single 5-pin DMX feed and passes it to two fixtures in parallel. It is built for the Electro T4 and T5 tubes, where a pair of tubes often sits on the same vertical and running two separate cables back to the node wastes both cable and time.

The housing is a short moulded Y with locking 5-pin connectors on all three legs, so it hangs off the fixture rather than dangling on a loop of cable. This is a passive split, not a buffered splitter, so keep the total run inside normal DMX limits.